Description
One set of 6 individual gradient flame stickers.
One set of 6 individual ANTI CLOCKWISE gradient flame stickers.
THESE ARE LARGE flame gradient symbols for use on a gas stove/hob in an ANTI CLOCKWISE direction (see listing picture with measurements - please check your stove to ensure these LARGE stickers will fit).
These stickers are designed to replace worn stove/cooker markings. They are reasonably hard wearing but whether they are as hard wearing as the original manufacturer's applied version - only time will tell - but so far so good.
They are made of heat resistant material and will withstand boiling water and will self extinguish if subjected to a flame test. The print is protected by a thin layer of transparent vinyl and as a consequence they are able to withstand normal cleaning with a cloth.
Please note these stickers are not calibrated or designed for any specific oven or stove. The buyer should check to ensure the sticker markings match those being replaced. Mismatched markings can be a safety hazard.
Each transparent self adhesive sticker is sized 6mm wide and extends in a semi circle covering an arc of about 165 degrees with the arc having a radius of 25mm (50mm diameter to the inner edge). In the listing picture, the edge of each sticker is outlined in magenta but this is only for illustrative purposes to show the outer dimensions. The magenta coloured lines are not printed on the version you receive. The diameter is relatively wide and its important that you check the diameter of you stove's dials to ensure that these LARGE flame stickers will fit and not overlap.
They are very easy to apply but before applying please ensure the stove/cooker hob surface is very clean and thoroughly dry before attempting to position the sticker.
Then simply peel off each sticker from its paper backing (you might need to bend the backing slightly to allow the sticker to be peeled away) and apply one at a time to the stove's surface.
It is suggest you take your time and pre-plan where you are going to place the stickers so that the final outcome looks symmetrical and neat. Once in position, rub the sticker to remove any air bubbles.
These stickers are available ONLY in BLACK print which shows well on silver and light coloured backgrounds.
*NOTE : PARTS ARE NON RETURNABLE FOR REFUND OR EXCHANGE*
We strongly recommend that you remove the part that is faulty and check it out. Compare carefully with the model number and photo and information above. If you don't see your model number here or the part you have is not similar to the above photo, or you are not sure, please send us your request by email to info@homeappliancesonline.co.nz We will reply back to you as soon as possible with the right part.
Selecting the wrong part and returning it is possible, but there will be a 20% restocking fee involved, which the supplier is charging us.
