Electrolux AEG Washing Machine Shock Absorber 80N 1327642003 251

Replacement standard shock absorber for selected Electrolux and AEG front-loading washing machines and washer dryers. This dual-stage damper controls movement of the suspended tub during washing and spinning. Replacing a worn damper can help reduce excessive bouncing and knocking where suspension wear has been confirmed.

Key Features

• Part number: 1327642003
• Standard shock absorber without an integrated sensor
• Damping resistance: 80 N
• Dual-stage damper
• Manufacturer-listed dimensions: 215 × 50 × 50 mm
• Supplied individually.
• Common Signs You May Need a Replacement
• Excessive vibration during spinning
• Tub bouncing or knocking against the cabinet
• Worn mounting bushes
• Damaged damper body or mounting points
• Reduced resistance confirmed during inspection

These symptoms do not confirm a damper fault by themselves. Check load balance, machine levelling, springs, counterweights and drum bearings before ordering.

Replacing Other Dampers

Inspect every damper and replace the complete worn set where necessary to restore consistent suspension resistance.

Some compatible machines also use a separate sensor-equipped damper. This standard damper replaces only the position specified for 1327642003; it must not replace a sensor damper. For example, the L98690FL parts list specifies two standard dampers and one sensor damper. 

Size and Technical Information

The listed 215 × 50 × 50 mm dimensions are overall catalogue measurements, not confirmed compressed or extended mounting-centre measurements. The 80 N rating describes damping resistance, not laundry capacity.

Installation Guide

1. Unplug the appliance, turn off the water and drain residual water.
2. Keep the machine upright and gain access using the model-specific procedure.
3. Support the tub and record the original damper position.
4. Release the mounting-pin locking tabs and withdraw the pins.
5. Remove the old damper and inspect the mounting brackets and pins.
6. Install the replacement in the same orientation and secure both pins.
7. Refit panels and test the machine for leaks, vibration and abnormal noise.

Use a competent appliance technician if access or mounting arrangements are unfamiliar. Follow Electrolux’s illustrated shock absorber replacement guide, together with the instructions for your exact appliance. support.electrolux.co.uk

Compatibility – check model label and PNC. Some Monel number is this page has got 2 different shock absorber , the other one is with sensor which listed below this page

The following models use this standard damper in at least one suspension position. This does not mean that every damper fitted to the machine is the standard type.

Compatible with the following models:

Models using both standard and sensor-equipped shock absorbers:

Sensor fitment was checked in specific parts lists; confirm other PNC revisions individually. 

Models manufacturer-listed for both damper types—exact PNC fitment needs confirmation:

These are model/PNC mappings, not confirmation that every production revision uses the same damper arrangement. 

Models listed for standard damper 1327642003, with sensor fitment still unconfirmed: